Yarara
2025
0.0.17 - June, 20th 2025
Changes
Added support of new CAN - BT module
0.0.16 - April, 30th 2025
Changes
Improvement of engine key switch off detection that could generate problems in some unstable situations
0.0.13 - March, 3th 2025
Changes
Added 2025 Bike Model Management
Added Management of new HBS2
Enable second injector during LC if is configured
Added Raptor 700 MY23 Management
Fixed a problem related to 0 position of stepper motor during KEY OFF
2024
0.0.12 - June, 28th 2024
Changes
Improved reliability of engine start-up
Fixed a bug and improved the management of ISC motor on 450 models
0.0.11 - April, 18th 2024
Changes
Improved reading of pick-up signal
Ignored fuel trim correctrion at engine idle condition.
2023
0.0.10 - September, 19th 2023
Changes
Added map change event to software. Available this feature from ver : 1.2.56.0 of Spark
0.0.9 - July, 28th 2023
Changes
Add possibility to configure Spare channels input for barometric pressure calculation
0.0.8 - April, 13th 2023
Changes
Added electric water pump management. Compliant only with : BOSCH PWM (code 0 392 023 232) or (code 0 392 023 454)
0.0.7 - February, 24th 2023
Changes
Increase frequencies reading of lean angle sensor
Added quick shifter button sensitivity management
Added quick shifter operation mode selection
Added barometric offset value compensation during automatic mode
0.0.6 - January, 11th 2022
Changes
Fixed a bug related to launch control activation
Managed 0 value on quick shift time table cut
2022
0.0.5 - December, 21th 2022
Changes
Fixed a bug related to crank correction that appear when UC bridge was connected to ECU
Optimized automatic barometic calculation algorithm
0.0.4 - July, 21th 2022
Changes
Improved analog sensors reading
Improved ecu temeprature calculation
0.0.3 - July, 6th 2022
General
First release