Go to the homepage Go to the italian page
Home page > Kart > Sensors > Accelerator/brake pedal position sensors
Accelerator/brake pedal position sensor
The new AIM accelerator/brake pedal position sensors represent a key support for kart drivers.
They provide a precise indication of timing and intensity of braking/ acceleration.
Which permits to understand if the driver has accelerated or braked at the right moment and with the correct strength. A very important fact to evaluate driver behavior and improve his performance.

Data can be acquired by MyChron4 connected to MyChron Expansion or to eBox Extreme and analyzed on your PC.
Made in anodized aluminium, these sensors are very robust. They are water-resistant, too.
Installation is quite easy, as shown in the installation examples.
Even calibration is immediate. Once installed, connect the sensors to MyChron Expansion or to eBox Extreme and get pedal positions (in high position and zero position): after that the sensor will start getting acceleration/braking data.
Here below you can download the datasheet and the photos of the sensor:
MyChron Expansion
eBox Extreme
Accelerator/brake pedal position sensor - Installation examples Accelerator/brake pedal position sensor - Race Studio 2 screenshots
Connectable to MyChron Expansion and eBox Extreme
  
Installation examples
  
Race Studio 2 Analysis screenshots
Accelerator/brake pedal position sensor - Scheme 1
Accelerator/brake pedal position sensor - Scheme 2