Engine Data Bridges
AiM products for bike
The easiest way to show engine data on visors and SmartyCam videos
ECU Bridge/RPM Bridge
ECU Bridge and RPM Bridge: these two systems are needed whenever engine data are to be visualized on a display or on a SmartyCam HD video, if no recording is required.
They are compatible with the SmartyCam HD and SmartyCamGP.
ECU Bridge is to be used in case the Engine Control Unit transmits data in the following hardware protocols: OBDII, CAN or RS232.
AiM has developed hundreds of different protocols, to make compatibility with virtually all ECUs possible, either stock and after market ECUs.
ECU Bridge has to be properly configured with Race Studio 2 software to communicate with the different visors/cameras on one side and ECUs on the other side.
ECU Bridge
connection
example
RPM Bridge
connection
example
ECU compatib.
with AiM
products
AiM ECU Bridge con connessioni
CAN/RS232 connection
ECU Bridge is available in two variants:
With OBDII connector, for immediate plug&play connection to the OBDII port of bikes with stock ECUs.
With CAN/RS232 connection, for direct installation on aftermarket ECUs.
AiM has also developed dedicated versions for Suzuki, Kawasaki and Ducati.
RPM Bridge is to be used whenever the bike has got no ECU (i.e. classic bikes).
In this case RPM data can be obtained with connection to the coil or reading a square wave signal generated by the ignition system.
© 2017 AiM Tech Srl - All rights reserved | Via Cavalcanti, 8 20063 Cernusco sul Naviglio - Italy | Tel. +39.02.9290571